If blade alignment is incorrect, add a few drops of oil to the blades, switch on the clipper for a few
moments, switch off and unplug. Loosen screws slightly and adjust. Tighten screws after blade is
aligned.
OIL
To maintain your clipper in peak condition, the blades should be oiled after every haircut.
Do not use hair oil, grease, oil mixed with kerosene or any solvent.
BLADE LEVER
The lever is conveniently located on the side of the unit so it can easily be adjusted while the clipper
is in your hand.
The lever adds versatility to your clipper by allowing you to gradually change the closeness of your cut without
an attachment comb.
When the lever is in the uppermost position, the blades will give you the closest cut and leave the hair very
short. Pushing the lever downward gradually increases the cutting length.
In its lowest position, the lever will leave the hair approximately the same length as a #1 comb.
The lever will also extend the use of your blades since a different cutting edge is used in each setting.
In addition, if extremely heavy hair cutting has jammed the blades, the level will help to remove the jammed hair
without disassembling the blades.
While the clipper is running, rapidly move the lever from “close cut” to “longer cut” a couple of times.
Doing this each time after you have finished using your clipper will help to keep the blades clear of hair.
If your clipper stops cutting and this does not help, your cutting blades are worn out. Replace them with new
blades.
IMPORTANT SAFEGUARDS
Please read this instruction manual carefully before use and keep in a safe place for future
reference.
Before the first use of the appliance check that the voltage indicated on the rating label corresponds
to the mains voltage in your home.
For home use only. Do not use for industrial purposes. Do not use the appliance for any other
purposes than described in this instruction manual.
Do not use outdoors.
Always unplug the appliance from the power supply before cleaning and when not in use.
To prevent risk of electric shock and fire, do not immerse the appliance in water or any other
liquids. However if this does occur DO NOT TOUCH the appliance, unplug it immediately and
contact your near service center.
Do not take this product to a bathroom or use near water.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliances by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Do not leave the appliance switched on when not in use.
Do not use other attachments than those supplied.
Do not operate after malfunction or cord damage.
Do not attempt to repair, adjust or replace any parts of the appliance. Check and repair the
malfunctioning by contacting Sytech Service Center.
Keep the cord away from sharp edges and hot surfaces.
