Do not place or store the appliance where it can fall or be pulled into a tub or sink.
Do not pull, twist, or wrap the power cord around the appliance.
Never insert any objects into the openings of the appliance.
Before use, make sure that blades are adjusted properly.
Do not place the appliance while it is operating on any surface, it may cause injury or damage.
Do not use the appliance with a damaged comb, or with teeth missing from the blades as injury
may occur.
NOTE: KEEP THE BLADES OILED
Do not use the hair clipper when the skin is infected.
Do not use the hair clipper on animals.
The manufacturer reserves the right to introduce minor changes into the product design without
prior notice, unless such changes influence significantly the product safety, performance, and
functions.
INSTRUCTIONS FOR HAIR CUTTING
Attachment Combs
Attachment Comb #1 leaves 3mm hair length.
Attachment Comb #2 leaves 6mm hair length.
Attachment Comb #3 leaves 9mm hair length.
Attachment Comb #4 leaves 12mm hair length
Attaching the Combs
To attach the comb, hold it with its teeth upward and slide it along the sides of the hair clipper until
the comb firmly adjusts onto the sides and you hear the “click” sound.
To remove the comb, simply pull the comb upward and away from the clipper.
BEFORE STARTING THE HAIR CUT
Check the clipper, making sure that there is no oil between the cutting blade teeth. Turn the unit on
to distribute the oil and to make sure it is running smoothly before using. Wipe off any excess oil.
This should be done before each use.
Select the desired attachment comb (see above) and fix it onto the clipper as indicated.
Seat the person so the head is approximately at the eye level. This allows ease of visibility while
cutting and a better control of the clipper.
Place a towel around the neck and shoulders of the person getting the haircut.
Before cutting always comb the hair so it is tangle free.
REMINDERS
Cut the hair in an even and slow manner. Use short strokes only and work gradually over the entire
head.
Always take off a little hair at a time; you can always trim off additional hair later.
As you work, comb the hair frequently back into the style to which you are cutting.
When cutting with this hair clipper it is better to leave the hair dry, not wet. With dry hair, it is much
easier to control the amount of the hair being cut.
Cutting hair requires practice so it is always better to leave the hair longer for the first few haircuts
until you become used to the hair clipper levels and how much hair does each level cut.
STEP 1-BACK OF THE NECK
1.
Attach the 3mm or 6mm comb.
2.
Hold the clipper with the cutting edge pointed up and begin the haircut by starting at the center of the base
of the neck (see diagram 1).
3.
Hold the clipper comfortably in your hand and hold lightly against the head with the comb teeth pointing
upward. Gradually and slowly lift the clipper, working upwards and outwards.
4.
As you cut, gradually lift the hair clipper head towards you. Continue to cut the back area from the bottom of
the neck upwards to the top of the ears.
