5.4 Condensation drainage
In general no condensation drainage is needed for rotational heat exchangers at dry conditions. However,
if a lot of humid air is present in the residence, a condensation drainage might be needed. Drainage
connection is available as an accessory and can be ordered seperate.
Note:
The drainage connection is plugged in the bottom of the unit at delivery. To use the drainage: elevate the
unit from the floor, remove the rubber seal and and connect the water hose. Connect the water hose to the
sewer. The water can not be led straight to the sewer without a water trap.
5.5 Electrical connections
The SAVE VSR 300/500 is wired internally from factory.
The electrical connection box can be found beneath the top cover. The print card can easily be taken
out from the unit.
1
1. Print card
5.5.1 Print card layout
The SAVE VSR 300/500 is equipped with built-in regulation and internal wiring. See below illustration for
an overview of the enclosed components.
The figure shows the print card. See wiring diagram for more information.
SAVE VSR 300/500
Installation and Service
208115
6
Systemair AB
Summary of Contents for SAVE VSR 300
Page 4: ......
