Return Time
: Set the dwell time before move to previous position once tracking is
inactive. (Off, 3~99 seconds.)
Lost Mode
: Choose “Stop” or “Zoom Out” when object has been lost.
Stop : Stop Tracking in current position when object lost.
Zoom Out : “Zooming Out” will be activated in 3 seconds after object was lost.
However this can not work if you switched off “Zoom Enable”.
Object Size
: Set the min/max size.
Exclusion Area
: Set the exclusion area.
View Angle Limit : Set to enable or disable limits of view angle during tracking.
On
: Enable limits of view angle only during tracking.
Off
: Enable limits of view angle during tracking always.
Right Limit
: Set 0.0 ~ 359.9
Left Limit
: Set 0.0 ~ 359.9
High Limit
: Set 0.0 ~ 180.0
Low Limit
: Set 0.0 ~ 180.0
Follow steps as below to set the Tracking:
1. Set the Zoom Enable.
2. Set the lost mode.
3. Select the object size and the exclusion area.
Follow the procedure of the detection above to the object size and the exclusion area.
4. Select the Exit (with saving) and push the Joystick to the right. Press ESC to exit the program
without saving.
Note : If you set to the sensitivity of tracking, select the motion in event function. Then set
to the sensitivity of motion. Select to the tracking in event function again.
Note : Auto tracking will be activated with an indicator (+) focused on the center of the
object
Note : Malfunctions in Auto Tracking might occur for the following cases:
- The object brightness is almost identical to the background luminance or in
environments with extreme low light conditions
- Water drop or damp on the Dome’s Bubble
- An environment with extreme changes in illumination
- An environment where there is excessive other non-target movement
- An environment where there is extreme twinkling or lambency on the object
- Movement too close to the camera optical axis
- Movement of the target in the vicinity directly below the camera
- Target movement that is very fast or very slow
- When the moving objects are either large or small in comparison to the preconfigured
object size
- When the camera is unsteady due to improper installation
24
