Synthes
33
3
Insert locking bolt/screw
Instruments
314.75 Hexagonal Screwdriver
321.20 Ratchet Wrench, 11 mm width across flats
357.386 11.0 mm/8.0 mm Protection Sleeve
357.398 Cannulated Shaft with 8 mm hex
357.515 Ball Hexagonal Screwdriver, 8 mm
Insert the appropriate 4.9 mm locking bolt or 5.0 mm locking
screw through the protection sleeve using the hexagonal
screwdriver.
Remove the protection sleeve and aiming arm. Note the inser-
tion depth of the nail as indicated by the rings on the insertion
handle. This will help in end cap selection. Remove the con-
necting screw and insertion handle using the ball hexagonal
screwdriver or the cannulated shaft and ratchet wrench.
Note:
If using SureLock, the insertion handle should remain
attached to the nail.
