4
Synel Industries Ltd.
Installation
Stand-Alone Terminals
2.
Installation
2.1
General
The unit can be installed in any building. The back panel of the unit serves as
an installation template. Mounting screws and anchors are also provided. Fol-
low the guidelines below:
•
The installation location selected should be as far away as possible from
an electrical power source reference such as power equipment, comput-
ers, motors, pumps, etc.
•
Use a linear power supplier and not a switching power supplier. A
switching power supplier auto-generates an electro-magnetic field that
shortens the reading range
It is advisable to connect an independant
power supplier to the reader.
•
It is recommended that when swiping the badge it will face the reader.
Thus, the badge will receive maximal energy.
PRX-40/A:
•
If you are installing more than one Synel reader, make sure the readers
are installed at a distance of at least 50 cm from one another (a distance
longer 5 times their reading limit).
•
Near metal objects reading range may decrease.
When mounting on a gypsum wall, make sure that there is no rear metal-
lic reinforcement. If the reader is mounted on a concrete wall the reader
must be mounted up to 20 cm from the wall.
•
Use a power adaptor dedicated to the proximity reader-controller access
unit. Make sure the adapter carries a safety recognition marking: UL,
CSA or CE.
2.2
Mounting
Option A
1.
Remove screw covers and screws from top and bottom of the unit.
2.
Open the back of the unit.
3.
Drill both fastening holes at either end and one hole towards the center
for the cable.
4.
Fasten the back of the unit to the wall.
5.
Connect the cable wires via middle hole or bottom hole option (see
diagram).
