Back to Table of Contents
5
1
Introduction
The PRX-40/B reader and PrintX-FPR fingerprint reader Standalone, as a stand alone biometric
solution for access control.
The proximity and biometric units are adjacently installed at sensitive
locations for granting access to secure zones.
Setup, management of authorized, and definitions are all done directly on the
units. Defining parameters in PRX-40/B and PRintX-FPR is simple, and the
templates and an authorized list are created and edited using the keyboard.
P
RX-40/B & PrintX-FPR were developed as compact, easy-to-use terminals,
granting access to secure areas. They work with various unit settings,
according to a predefined security level. These devices are made of strong
ABS plastic.
Defining parameters is simple while maximum security is enabled by using
the set-up 8 digit code (the default number is 12345678) maximizing security.
In stand alone mode these units grant secure access for approximately 285
card holders, stored in an authorized list within the terminal. This list is created and edited on the
unit’s compact keyboard, eliminating the need of connecting to a computer.
These terminals can manage unauthorized (black list) or authorized (white list) employee lists for
access control purposes.
The PRX-40/B and PRintX-FPR Standalone can be used in the following modes:
Identification
- In this mode user is only identified by a fingerprint and is not verified by an
additional means of identification.
The finger is placed on the sensor and is either accepted or rejected immediately.
In this mode, the keyboard unit can be installed in a different location such as on the other side of the
door. In this case The user is identified my finger on one side and by card or pin number on the other
side of the door.
Identification mode supports up to 9,000 authorized people.
