Back to Table of Contents
36
beeps will indicate that the index was deleted successfully. After swiping all cards press 7&8 simulta-
neously (mandatory) (press
Enter
in terminals that consist of an
Enter
key) in order to revert to nor-
mal mode.
1.2.5 Terminology
Card Only - Control is performed by Card only.
Global Code only - common global code (4 digit code – used by all card-holders).
Card or code - Control is performed by Card or keying-in number of card (the length of the keyed-in
number must be identical to the defined card length).
Card and Global Code - Control is performed by Card and a common global code (four digit code –
used by all card-holders).
Card and PIN Code – Control is performed by Card and a personal four digit code. This mode is the
most secure.(4 digit code – used by each card-holder).
1.2.6 General definitions
Open Door
Access can be given by using a Master Code. After entering “Programming Mode,” enter “0”.
Open Door Time
It is possible to adjust the “window” of accessibility during which a door opens when accessed. To
change the accessibility time, after entering the “Programming Mode,” enter “10” and then four digits.
For example if you enter 0015, the accessibility time is 1.5 seconds.
Set Global Code
You can change a Global Code by way of “Instruction Code” – 15. After entering “Programming Mode”
enter “15” and afterward a four digit number that will be the new Global Code.
Set New Master Code
The Master Code can be change by way of “Instruction Code” – 13. After entering “Programming
