Synapius ECS 20 Series, User And Installation Manual

Page: 14 / 37

Clear ing all the user pin codes
The user pin codes from 1 to 99 can be cleared in a single procedure.
Follow the next procedure to perform this.
Press CE to clear existing keystrokes
xxxxxxxx enter the master code
now, the red LED goes on, which means the device is in programming mode
00000000 enter eight zero’s
Confirm clearing the user codes otherwise press to cancel
Clearing the user codes takes a little time thus wait until the green LED turns off before proceeding.
Clear ing a sin gle user
To clear a single user position and the corresponding pincode you must store 00000000 (eight zero’s)
as user pincode. This will replace the user ID number with blank. For this reason a user pincode
consisting of eight zero’s is a non valid pincode for normal usage.
Read ing the number of E- stops of an in di vid ual user
If the E-stop handling function 2 is active (re-start by the user code) the number of E-stops are
recorded for each individual user. This number of E-stops can be read out. To do this follow the next
procedure.
To clear existing keystrokes
xx user number (2 digits)
The Red and green LED’s flashes to indicate the number of E-stops.
The red flashes the ten’s and the green flashes the one’s. Also, multiplying the red flashes by ten and
then adding the number of green flashes gives the total of E-stops.
For example: If a user caused 23 E-stops, reading out results in two red flashes and three green flashes.
To clear the E-stop counter, for a user xx, just reprogram the user pincode at the same user xx place.
This might be the same or a new pincode.
Note:
Although the user numbers 98 and 99 are valid user numbers, the recording of E-stops is not applicable
to this two user numbers for this numbers are reserved for reading the two last users.
Electronic Code Switches