Symmetricom TimeProvider 100, User Manual, Page: 79 / 124

098-00106-000 Revision A – March, 2009 TimeProvider 100 User’s Guide 79
Chapter 5 CLI Commands
Set Commands
Response:
tp100>
set output
This command is used to configure the four telecom output ports. Parameters are
frame type, SSM bit position, and whether the port is enabled.
Input:
tp100> set output <tab>
Response:
port1 port2 port3 port4
tp100> set output
Input:
tp100> set output ?
Response:
port1 - Output port 1
port2 - Output port 2
port3 - Output port 3
port4 - Output port 4
tp100> set output
Input:
tp100> set output port2 <tab>
Response:
frametype ssm-bit state
tp100> set output port2
Note
: When an Ethernet port is in static mode,
set ipconfig
mgmt restart
will activate a newly entered IP address. When the
Ethernet port is in the DHCP mode,
set ipconfig mgmt restart
will try to acquire an IP address within 60 seconds. Use
ipstatus
to
confirm the port configuration after using the
set ipconfig mgmt
restart
command.