2-4-1
PZ3PDMDA
DISASSEMBLING / ASSEMBLING
Tools and measurement equipment
Tools
1) (+) type Screw Drivers: to screw the screws
2) Air Blower
3) Earth Ring
4) Small Driver: to adjust potentiometer
5) Dummy Discharge Resistor: 2.4 k
Ω
/ 10 W
Measuring Equipment
1) Oscilloscope: 500 MHz sampling
2) Probe: 10:1
3) Digital Multi-meter
4) Signal Generator
Disassembling & Re-assembling
Disassembling & Re-assembling of FPC (Flexible Printed Circuit) and Y-Buffer
1. Removal procedures
1) Full out the FPC from Connector by holding the lead of the FPC with hands.
2. Assembling Procedures
1) Push the lead of FPC with same strength until to be connected completely.
* Notice: Be careful do not get a damage on the connector pin during connecting by mistake.
Summary of Contents for 6842THG
