9. Setup
a) IR remote control
•
If a small transparent plastic strip protrudes from the bottom of the IR remote control, the
battery is already inserted. Pull the plastic strip out of the IR remote control and then it
will be ready for use.
•
To change the battery, simply pull out the battery holder on the bottom of the IR remote
control. Replace the depleted battery (1x CR2025) with a new one. Push the correctly ori-
ented battery holder back into the IR remote control (the plus pole/+ of the battery should
point towards the bottom of the IR remote control).
A battery change is required if the IR range has decreased significantly over time
or the code lock is no longer responding to the IR remote control.
b) Code lock
•
Switch on the operating voltage after installation and connection.
• The fingerprint sensor illumination is activated briefly and the code lock emits a short
beep. The control LED (see chapter 7, item A) on the top of the code lock lights up red.
•
You can now start programming, see next chapter.
22
