-10-
Please follow the following recommendations when cleaning and
inspecting lenses and reflectors:
Do not
use glass or window type cleaners on lenses (glass or polymer) or
reflectors.
Do not
use abrasive materials such as steel wool.
Replace lenses if they contain visible damage (cracks or deep scratches) that may impair their
effectiveness.
Cleaning the reflector
To quickly clean the reflector, remove the lens tube and clean the dust from the reflector with a blast of
oil-free air. You may also wipe the reflector with a clean lint-free cloth. If either method is not sufficient,
follow the instructions below. You will need a screwdriver to complete this procedure.
1.
Remove the barrel rotation knob located at the bottom of the barrel. Use a screwdriver to remove the
retainer bolt located on top of the reflector housing.
2.
Rotate the barrel 45° in either direction. Carefully remove the barrel from the reflector housing.
3.
Dampen a clean lint-free cloth with alcohol or distilled water. (Alcohol is recommended.)
4.
Gently wipe the reflector.
5.
Insert the barrel into the reflector housing with the iris/pattern slot on top. (Line up the triangles on
both parts.)
6.
While pressing in gently,rotate the barrel 45° clockwise until it sets into position. Then, rotate the
barrel counterclockwise 45°, The barrel should be firmly attached and the triangles should line up
again.
7.
Replace the barrel rotation knob and tighten the retainer bolt.
WARNING!
Unplug the fixture before attempting to clean the reflector.
Cleaning 19° , 26° , 36° , and 50° glass lenses
1.
Remove the beam focus knob at the bottom of the barrel. Remove the lens tube from the barrel.
Note:
It is not necessary to remove the lens for cleaning. If you do remove the 19°,26°,or 50°
lens. make sure the identifying paint dot is not removed during cleaning.
2.
Dampen a clean lint-free cloth with vinegar or household ammonia. You may also use water, but it
will leave spots that can be removed by gently polishing the lens with a clean and dry cloth.
3.
Starting from the center, gently wipe the lens.
4.
Slide the lens tube back into the barrel with the color frame retaining clip on top. Replace the beam
focus knob.
Cleaning
TECHNICAL SPECIFICATIONS
Power supply: REFER TO the lamps you choosed
Power consumption Max. 750W
Dimensions (L x W x H); 270 x 270 x 570mm
Weight; 2.4 kg
Fitting lamp GKV 600W Halogen lamps Base: GX9.5
Maximum ambient temperature t
a
: 25°C
Maximum housing temperature t
S
: 160°C
Minimum distance: 2 m
