Page 13
Set Time of Day
The user can also set the time of day. Time of day should only need to be set
after power outages lasting more than 8 hours, if the battery has been depleted
and a power outage occurs, or when daylight saving time begins or ends. If a
power outage lasting more than 8 hours occurs, the time of day will flash on and
off which indicates the time of day should be reset. If a power outage lasts less
than 8 hours and the time of day flashes on and off, the time of day should be
reset and the battery replaced.
STEP 1-UD
– Press SET CLOCK.
STEP 2-UD
–
Current Time (hour):
Set the hour of the day using
or
buttons. AM/PM toggles after 12. Press NEXT to go to Step 3-UD.
STEP 3-UD
–
Current Time (minutes):
Set the minutes of the day using
or
buttons. Press NEXT to exit Set Clock. Press REGEN to return to previous step.
Power Loss
If the power goes out, the system will keep time for up to 8 hours or until the battery is depleted. If a power outage of
more than 8 hours occurs, the time of day will flash on and off which indicates the time of day should be reset. The
system will remember the rest. If a power outage lasts less than 8 hours and the time of day flashes on and off, the
non-rechargeable battery should be replaced.
Error Message
If the word “ERROR” and a number are alternately flashing on the display, this
indicates that the valve was not able to function properly. See
Troubleshooting &
Error Code Guide for Tech Control Valves
for help diagnosing error codes or
contact manufacturer for help.
Step 1-UD
Step 2-UD
Step 3-UD
