Page 12
User Display Settings
General Operation
When the system is operating, one of two
displays will be shown. Pressing the NEXT
button will alternate between the displays.
One of the displays is always the current time
of day. The second display is one of the
following: days remaining or capacity
remaining. Days remaining is the number of
days left before the system goes through a
regeneration cycle. Capacity remaining is the
number of gallons that will be treated before
the system goes through a regeneration
cycle. The user can scroll between the
displays as desired.
If the system has called for a regeneration that will occur at the preset time of regeneration, the words “REGEN
TODAY” will appear on the display.
When water is being treated (i.e. water is flowing through the system) the word “SOFTENING” or “FILTERING”
flashes on the display if a water meter is installed.
Regeneration Mode
Typically, a system is set to regenerate at a time of low water usage. An example
of a time with low water usage is when a household is asleep. If there is a
demand for water when the system is regenerating, untreated water will be used.
When the system begins to regenerate, the display will change to include information about the step of the
regeneration process and the time remaining for that step to be completed. The system runs through the steps
automatically and will reset itself to provide treated water when the regeneration has been completed.
Manual Regeneration
Sometimes there is a need to regenerate the system
sooner than when the system calls for it, usually referred to
as manual regeneration. There may be a period of heavy
water usage because of guests or a heavy laundry day.
When the regeneration time option is set to “NORMAL” or “ on 0,” press and release the REGEN button
to initiate a manual regeneration at the preset delayed regeneration time, The words “REGEN TODAY” will flash on
the display to indicate that the system will regenerate at the preset delayed regeneration time. If the REGEN button
is pressed in error, pressing the button again will cancel the request.
NOTE: If the regeneration time option is set to “on 0” there is no set delayed regeneration time so “REGEN TODAY”
will not activate if the REGEN button is pressed.
To initiate a manual regeneration immediately, press and hold the REGEN button for 3 seconds. The system will
begin to regenerate immediately. The request cannot be cancelled.
NOTE: For softeners, if the brine tank does not contain salt, fill with salt and wait at least 2 hours before regenerating.
OR
REGEN TODAY
will be displayed if
a regeneration is
expected “Tonight.”
REGEN TODAY
will flash if a
regeneration is
expected “Tonight.”
