20
Page
Version 1.1 March 2021
Step 9: Attach the Solar Panel (Part E) JST-2 plug to the JST-2 connector on the SunAirPlus2 (F) board as
shown above.
Step 10: Attach the USB Cable (Part B) to SunAirPlus2 (Part F) as shown above.
Step 11: Plug in the 20cm Grove Cable connected to the MiniProPlus (Part A) (plugged into J7-I2C) into the
SunAirPlus2 board Grove connector as shown above.
Step 12: Attach the SunAirPlus2 board (Part F) to the bottom box (Part I) using two 5mm screws as shown.
Step 13: Check to see that the Box Plug (Part M) fits in the right side hole of the bottom box (Part I). If it
doesn’t, file the Box Plug (Part M) down until it does fit. And it should fit pretty snugly.
Step 14: Screw the Joiner (Part N) into the Box Plug (Part M). Don’t screw it all the way in. Just until it is
snug.
