Swissvoice XTRA 3355, User Manual

Page: 25 / 42

25
7.5. Change the Flash Time
Through telephone base:
1. Press Ok when idle.
2. Press or to select BS Setting , then press Ok .
3. Press or to select Flash Time , then press Ok .
4. Press or to select your desired flash time.
( Short , Medium , Long are for your selection), then press Ok to confirm. You hear confirmation tones.
7.6. Reset Your Phone
You can reset your phone to the default settings by using handset.
After reset, all your personal settings will be deleted and resumed to default factory settings, but your phonebook
and other memories remain unchanged except redial list.
Through telephone base:
1. Press Menu when idle.
2. Press or to select BS Setting , then press Ok .
3. Press or to select Default , then press Ok, Confirm? Is displayed, then press Ok to confirm. You
hear confirmation tones.
Through cordless handset:
1. Press
when idle.
2. Press or to select HS Setting , then press .
3. Press or to select Default , then press , Confirm? Is displayed, then press to confirm. You
hear confirmation tones.
8. Registration Cordless Handset to Telephone Base
8.1. Registration
Your handset and telephone base is pre-registered. If for some reason, the handset is not registered to the
base station, Put On BS will be displayed on the handset screen. If it is out of base and disappears on the
screen, register your handset according to the following procedure.
1. Make sure the handset is out of the base and shows
Put On BS before you begin registration.
2. Press and hold Page on the telephone base in idle mode for around 5 seconds until incoming call light LED
bar lits on the telephone base.
3. Press when idle.
4. Press or to select HS Setting , then press .
5. Press or to select Register , then press Ok , Registered appears and flashes on the screen until the
handset can be registered with base.
If registration fails, the telephone base screen displays Put On BS .
Pls. repeat the above procedure.
8.2. Locate the Cordless Handset
To locate the handset: On the base, press the key located under PAGE (on display) once.
All the handsets registered to the base will produce the paging tone and “ Paging ” is displayed on the LCD of
the handsets and on the base display.
You can stop the paging by pressing
, , on any handset or Page on the base again.
Note: If there is an incoming call during paging, the phone will ring with the incoming call instead of paging.
8.3. Conference Call
Up to 4 cordless handsets and the telephone base can join an external call at the same time.
To join a call with the telephone base:
• Press to join the call,
• Press again, to exit the call.
• Lift up the Corded handset to join,and return to cradle to exit.
To join a call with a cordless handset:
• Press join the call.
• Press or place the handset in the base or charger to exit the call.