Swing-N-Slide Tunnel Twister, Assembly Instructions Manual, Page: 8 / 24

Fig. 5
E. Second Elbow and Slide Exit
1.
Align the seams of the second Elbow Section to
the First Elbow Section as shown in
(Fig. 5) .
2. Secure in place as shown in (Fig. 5) .
3. Attach exit section so that the Slide Base is level
on the ground, as shown in
(Fig. 5a) .
4. Use the Slide Bracket to determine an appropriate
location for the 4'' x 4'' x 66'' Slide Support.
5. Dig a hole 18'' deep aligned with the previously
determined location as well as located near the
first bend of the slide as shown in
(Fig. 5b) .
Place the 4'' x 4'' x 66'' Slide Support in this hole
as shown and set in place.
6. Tighten all slide bolts securely.
Fig. 5a
(1) 3/4'' Bolt
(2) Flat Washer
(1) LocNut
Per Hole
(1) 3/4'' Bolt
(2) Flat Washer
(1) LocNut
Per Hole
Fig. 5b
18''
Ground Level
4
''
x
4
''
x
6
6
''
Tunnel Twister Assembly Instructions
8