7
@2021 Swellpro Technology Co., Limited
Aircraft Battery Installation
1. Remove the LID of the drone using the
thumb screws.
2. Insert the battery into the battery slot
from the tail of the aircraft to the head of the
aircraft, fasten the velcro strap snugly
around the battery, and then insert the
power plug into the power socket to
complete the installation of the battery.
3. Replace the LID and fasten the thumb-
screws snugly to ensure a good seal around
the LID.
Power Switch
There is a power switch at the head of FD1. Once the Battery is Connected, press and hold for 3 seconds
to power on, and press and hold again for 3 seconds to power off.
(At the end of the flight, please
disconnect the battery, otherwise the battery will be damaged if it is stored while still being physically
plugged in.)
Aircraft Status Indicator
The fuselage of the aircraft includes drone status indicator light (red) and GPS signal status indicator
light (green). Their location is shown in the figure below.
Low battery warnings
Two Red Flashes - First level low battery warning. Land as soon as possible.
Fast Red Flashing - Second level low battery warning. Drone will auto land.
Fr
on
t o
f
dr
on
e
Rear Green LED
Forward Red LED
