MS DARK SPY
drone
EN
BEFORE FLYING YOUR DRONE FOR THE FIRST TIME PLEASE DO THE FOLLOWING:
1. Fully Charge and then install the battery of the drone according to the manual.
2. Install the 4AA batteries in the remote controller according to the manual.
3. Carefully check drone rotor blades and rotor holders. Broken parts can cause risk of injury and will
effect on flight.
4. Drone battery should be properly attached to the battery holder. Still do not connect drone battery
with the drone.
5. Turn on the drone (make sure drone is in horizontal position) the green and blue LED lights will be
flashing.
6. Turn on the remote control.
7. Push the throttle lever forward, and push the throttle lever down, then you can hear “di di”, the
power no flashing any more, or the remote will match the drone automatically (wait for after hear “di
di” sound) after turn on the remote, means remote match drone successfully.
Make the gyro calibration according to manual, make the compass calibration according to manual, then
rotate the drone according to manual. Wait the drone search for GPS signal, when the LED lights (Head
white light or the green & blue lights) will be light on all the time, no flash any more. Then GPS flight
is pair successfully.
8. When turning off first turn off drone then remote.
9. When install the camera, please make sure the drone is turn off firstly.
HR BIH CG
KRATKE UPUTE ZA LETENJE PRIJE PRVOG KORIŠTENJA:
1. Potpuno napuniti i instalirati bateriju drona prema postojećim uputama.
2. Instalirati 4AA baterije u daljinski upravljač prema uputama u priručniku.
3. Pažljivo provjeriti elise i držač motora, pokvareni dijelovi mogu prouzročiti opasnost od ozljeda i
utjecati na let.
4. Bateriju drona treba pravilno pričvrstiti na držač baterije (još uvijek nemojte spajati bateriju s
dronom).
5. Uključite dron (provjerite da li je dron u vodoravnom položaju) zelena i plava LED svjetla će treperiti.
6. Uključite daljinski upravljač.
7. Pomaknite ručicu gasa prema naprijed, i nakon toga prema nazad. Čuti ćete zvučni signal „di di“, a
napajanje će prestati bljeskati. Daljinski i dron spajaju se automatski nakon što se upali daljinski
(pričekati „di di“ zvuk). Kalibraciju žiroskopa i kompasa napravite prema uputama te zarotirajte dron
prema uputama. Pričekajte dok dron pronađe GPS signal. Kada LED svjetla (bijelo svjetlo prednjeg dijela
drona ili zeleno i plavo) svijetle cijelo vrijeme uparivanje je uspješno završeno.
8. Prilikom isključivanja najprije isključite dron, a zatim daljinski upravljač.
9. Prije instaliranja kamere, provjerite da li je dron isključen
.
