16
@2021 Swellpro Technology Co., Limited
Remote control operation
Description
Pull down the left and right joysticks at the same time
and then push them to the inside. Hold this position for
3 seconds to unlock the motor.
Lock (stop) motor
Remote control operation
Description
Method 1: when the aircraft smoothly lands on the
ground, pull the throttle to the lowest level, hold for 3
seconds, and the motor will lock automatically.
(recommended)
Method 2: when the aircraft lands on the ground, pull
the throttle to the lowest level and hold it for 1 second
to let the aircraft enter the idle state, and then lock the
left and right joysticks to the outside (as shown in the
left picture).
Basic Flight Steps
1.
Install the battery correctly and lock the battery cover.
2.
Carry out the Compass Calibration
3.
Install the propellers correctly
4.
Turn on the remote control, and then turn on the DRONE.
5.
Place the aircraft on level open ground.
6.
Confirm that the flight control OSD data display is normal, and the battery power is Greater than 16V;
Remote control battery power Is greater than 7.2V; Satellite signal 8-10.
7.
For safety, it is recommended to stand at least 3 meters away from the upwind and the side of the
aircraft.
8.
We suggest Novices taking off in GPS mode.
9.
Push the throttle up slowly to make the plane take off smoothly. When the aircraft reaches 1.5
meters high, release the throttle and let the aircraft hover for a short period of time to observe
whether the aircraft is stable and in good condition. After confirmation, the flight operation can
continue.
10.
When it is necessary to descend, slowly pull down the throttle to make the aircraft descend to the flat
ground or water surface.
11.
After landing, pull the throttle lever to the lowest position and hold it for more than 3 seconds until
the motor stops.
Start/Land on Water
1.
When taking off on the water with waves, please increase the throttle and take off quickly to avoid
being affected by the waves.
