Swecoin TTP 5000, Service Manual

Page: 6 / 60

TTP 5000 Series Kiosk Printer Sub-system — Service Manual Edition B, May 97 4
TTP 5000
Control board SWC 492-000
Power requirement +24V, +5V
Power connector 6-pole
Firmware storage EPROM
RAM size 128 Kbyte
Parameter setting DIP switches
Data comm. interface(s) Serial RS 232 and parallel Centronics-type. The latter
requires a separate piggy-back mounted PCB
assembly.
Data comm. connectors Ribbon cable-type connectors. Standard DIN and
Amphenol connectors available through the use of
adapter cables.
TTP 5100
Control board SWC 728-001
Power requirement +24V and +5V
Power connector 6-pole
Firmware storage EPROM
RAM size 128 Kbyte
Parameter setting The board has no DIP switches. Parameter changing
requires an alternative EPROM capsule.
Data comm. interface(s) Serial RS 232 and parallel Centronics-type
Data comm. connectors Ribbon cable-type connectors. Standard DIN and
Amphenol connectors available through the use of
adapter cables.
Backward compatibility Fully backward compatible if the applicable EPROM
is installed.
TTP 5200
Control board SWC 728-002
Power requirement +24V and +5V
Power connector 6-pole
Firmware storage Flash PROM.
RAM size 256 Kbyte
Parameter setting New or modified parameters can be set through
software commands. Complete set of parameters can
be downloaded on-line.
Data comm. interface(s) Serial RS 232 and parallel Centronics-type
Data comm. connectors Ribbon cable-type connectors. Standard DIN and
Amphenol connectors available through the use of
adapter cables.
Backward compatibility Fully backward compatible if the applicable firmware
is downloaded.