Swecoin TTP 5000, Service Manual, Page: 22 / 60

TTP 5000 Series Kiosk Printer Sub-system — Service Manual Edition B, May 97 20
Figure 6. Loosening the print module from the cutter module
On printers with movable print module, pull out the latch, raise the print module and slide
REPLACEMENT
1. Install the print and cutter module assembly in the reverse order. See page 34
(TTP 5100) or page 44 (TTP 5000) for correct connector positions.
2. Check that there is a 0.2 mm distance at any point between the rear edge of the
presenter module and the cutting knife. If necessary, adjust by loosening the fixing
screws of the print and cutter module assembly. A too big distance might cause the
paper running down between the cutter and the presenter modules.
Figure 7. Adjusting the distance between presenter motor and cutting knife