Swecoin TTP 101, Service Manual

Page: 23 / 56

0102 TTP 101 Kiosk Printer Sub-system – Service Manual 23
4.3.2 Printer module
REMOVAL
1. Remove the control board (see 4.3.1)
2. Remove the four rear screws on the underside of the printer.
Figure 9. Printer module securing screws
3. Remove the printer module by sliding it backwards. Four screws extending from the
cutter module guide the printer module. The holes in the printer module are not
threaded.
REPLACEMENT
Install the printer module in the reverse order while verifying that the head release lever at
the left side of the printer module enters the fork-shaped part of the head-release arm
mounted on the printer housing.
NOTE! Apply Loctite 242 on the cutter module securing screws
4.3.3 Printhead
REMOVAL
1. Remove the printer module (see 4.3.2).