GB
7
Electrical Safety
WARNING!
Always check that the power supply corresponds to the voltage on the rating plate.
WARNING! Connect the main leads to a standard 230V±10% (50Hz±1Hz) electrical supply
which has protection devices of under-voltage, over-voltage, over-current as well as a
residual current device (RCD) which maximum residual current rated at 30mA.
Replacing cables or plugs
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
Immediately throw away old cables or plugs when they have been replaced by new ones. It is
dangerous to insert the plug with a loose cable in the wall outlet.
Using extension cables
1. As a supply for this machine always use an unloaded line and/or extension with conductor of
at least 2.5mm
2
and protected with a 20A fuse. Be sure that this extension cable is not longer
than 10 meters. Excessively long cables or inadequate section can cause voltage drops that
prevent motor from developing its full power.
2. Only connect your machine and/or extension cable to earthed electricity mains.
Grounding
1. In the event of an electrical short circuit, grounding reduces the risk of electric shock. Use
switch socket with grounding please.
INTENDED USE
This log splitter is only intended to be used to split logs! Serious injury may occur if this log splitter
is used for any other purpose.
TECHNICAL SPECIFICATIONS
Model
VLS8T-02S-3A
Voltage:
230V~50Hz
Power consumption
3000W(S6,40%)
Idle Speed:
2,800min
-1
Classification
Class I
Protection degree
IP 54
Max. splitting force (tons)
8T
Log size capacity - Diameter
70-400mm
Cutting Length
580/770/1060mm
Max. Hydraulic oil capacity
6L
Max, hydraulic pressure
28MPa
