22
A-96.250.631 / 280219
AMI Codes-II TC
Installation
3.5.
Install the Option pH
3.5.1
pH as Option ex works
If the pH option was ordered with the AMI Codes-II TC, the pH sen-
sor cable as well as the temperature sensor are already connected
to the AMI transmitter.
1
Carefully pull off the protective cap [F] from the pH sensor [C]
by turning it clockwise.
2
Store the protective cap in a safe place.
3
Rinse the pH sensor tip with clean water.
4
Insert the pH sensor into one of the holes in the constant head
cover [E].
5
Insert temperature sensor [D] into the small hole.
6
Remove the connector cap from the connector of the pH sen-
sor. Store it in safe place.
7
Screw the connector [B] onto the pH sensor.
A
B
C
D
E
F
G
Connector cap
Connector
pH Sensor
Temperature sensor
Constant head cover
Protective cap
Constant head
B
C
D
A
E
G
F
