Swagelok 8HPH Series, User Manual

Page: 13 / 96

Series 8HPH Weld Head User’s Manual 11
Installing or Replacing the Electrode
The series 8HPH weld head tool package includes:
• a miniature hex drive
• wire brushes
• tweezers
• a hex wrench set
Use these tools for installing a new size of electrode, or for replacing
the electrode when it shows signs of deterioration.
Reducing the jog speed may be helpful for correct positioning of the
rotor.
1. To reduce jog speed, press SETUP on the operator panel.
2. Select CONFIG from the setup options.
3. Select a jog speed of 50 % or less.
4. Open the side plates by pushing each actuator handle back to
the open position. See Figure 13
Caution!
Do not press JOG or move the
rotor unless the electrode is
clamped in place .
Figure 12 Pressing SETUP on the
Operator Panel
Figure 13 Pushing Actuator Handles
to the Open Position
13-170.indb 11 2/1/13 1:45 PM