SVS-Vistek EC02 Series, Manual, Page: 64 / 131

SVS-VISTEK
Feature-Set 64
Example of an IOMUX configuration
>
The trigger signal comes in on
line 0
>
Debounce it.
connect line 0 to 8:
1000000000000000000000000
signal appears again on line 15 –
debouncer out
> Use the prescaler to act only on
every second pulse.
connect line 16 to 9.
0000000000000000100000000
signal appears again on line 17 –
debouncer out
>
Configure a strobe illumination
with pulseloop module 0
connect line 17 to 13
signal from pulse loop module 0
appears on line 6
connect line 6 to 0 (output 0)
> Set an exposure signal with
pulseloop module 1.
connect line 17 to 6
>
Tell another component that the camera is exposing the sensor.
connect line 17 to 14
signal from pulse loop module 1 appears on line 7
connect line 7 to 1 (output 1)
> Turn of a light that was ON during the time between two pictures.
connect line 17 to 15
invert signal from pulse loop module 2
it appears on line 20
connect line 20 to 2 (output 2)
Inverter & Set-to-1
Inverter and “set to 1” is part of every input and every output of the
modules included in the IOMUX.
I
N V E R T E R
The inverter enabled at a certain line provides the reverse signal to or
from a module.
S
E T T O
“ 1 ”
With set to “1” enabled in a certain line, this line will provide a high
signal no matter what signal was connected to the line before.
S
E T T O
“ 1 ” –
I N V E R S
The inverse of a set to “1” line will occour as a low signal, regardle the
actual signal that came to the inverter modul.