(31)
Symtom
7. The temperature is now flashing in the display and T2 is shown. Set desired temperature for time interval 2 (T2).
Confirm with .
8. The temperature is now flashing in the display and T3 is shown. Set desired temperature for time interval 3 (T3).
Confirm with .
9. The temperature is now flashing in the display and T1 is shown. Set desired temperature for time interval 4 (T4).
Confirm with .
10. The timer symbol is now shown in the display together with T1-T4 depending on which times you have set and what time it is.
50
OF
T2
T1
20:00
°C
New installation:
- The towel rail doesn't get warm
even though the display looks
normal
- The electrical element has been
connected to electricity without water
and the safety switch on the heater
as been activated. The heater is
therefore unworkable. See page 26.
- The right to reclamation is not valid in these cases.
T3
50
°C
OF
T4
Fault finding
Reason
Remedy
- The electric element is connected,
but nothing is shown in the display
- There is no power to the electric
element
- Check the electrical connections and that the control
panel is correctly assembled on the element.
See page 27.
- Cut the power and wait until the towel rail has cooled
off entirely. Turn on the power again.
- Check that the control panel is correctly assembled
on the element. See page 27.
- Check that the towel rail is filled with water
.
- Cut the power and wait until the towel rail has
cooled off entirely. Turn on the power again
.
- Assumed electronic error
- Assumed over-heating
- The temperature sensor has been
damaged
- The control panel is not correctly
assembled on the element
- The towel rail doesn't get warm
and E7 / E9 is flashing in the
display
- E6 is flashing in the display
- The towel rail is hot even after
the electric element has been
switched off with the On/Off button
- The clock is flashing (h and m)
- Power cut
- Set the time again
.
If the problems remain, please contact your dealer.
08:00
20:00
22:00
