Suzuki S-1800H80/180, Technical Manual

Page: 12 / 123

Refer to the Hoist does not raise or lower the soundome.
Refer to the "WAITING" stays more than 2 minutes.
[Bearing 0
°
and Scanning]
Bearing does not show 0
°
after Train starts.
Scanning starts after lowering the hoist and turning the Limit Switch on even if Bearing does not
show 0
°
"MENU 2" screen shows SELF CHECK -TRAIN NG
0
°
can not be adjusted while bearing.
Scanning is normal other than stopping temporarily.
"MENU 2" screen shows SELF CHECK -TRAIN NG
0
°
can not be adjusted and scanning stops occasionally.
"MENU 2" screen shows SELF CHECK -TRAIN NG only when the scanning stops intermittently.
Scanning is normal, though Train is inactive.
"MENU 2" screen shows SELF CHECK -TRAIN NG
[When Signal cable disconnected while operating.]
Hoist raises
Scanning stops
"MENU 2" on the screen shows:
SELF CHECK
DATA-TX NG
DATA-RX NG
DATA OK
HOIST OK
TILT OK
TRAIN OK
ROM-VER OK
OTHERS OK
-11-
"WAITING" stays more than 2 minutes and then "CHECK FUSE AT CONTROL-BOX" appears next.
Normal Display does not appear on the screen even when Sonar Mode is set.
(HOIST NG)
Scanning stops when Gain Dial/Far Gain Dial is turned.
Scanning stops when a Key is pressed.