Suzuki LT-A400, Service Manual

Page: 462 / 502

6B-11 Steering / Handlebar:
Steering Shaft Holder
Inspect the steering shaft holders for wear or damage. If
any defects are found, replace the steering shaft holders
with new ones.
Steering Shaft Bushing
Inspect the steering shaft bushing for wear or damage. If
any defects are found, replace the steering shaft bushing
with a new one.
Specifications
Service Data (LT-A400/F, LT-F400/F)
B827H16207001
Wheel
Unit: mm (in)
Tightening Torque Specifications
B827H16207002
NOTE
The specified tightening torque is also described in the following.
“Steering / Handlebars Components (Page 6B-1)”
“Steering Assembly Construction (Page 6B-2)”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List (LT-A400/F) in
Section 0C (Page 0C-9)”.
I827H1620046-01 I827H1620047-01
Item Standard Limit
Steering angle 47
°
(right & left) —
Turning radius 3.1 m (10.2 ft) —
Toe-in (with 75 kg, 165 lbs) 10
±
4 mm (0.39
±
0.16 in) —
Camber 0.3
°
—
Caster 3
°
—
Fastening part
Tightening torque
Note
N
⋅
m kgf-m lb-ft
Handlebar clamp bolt 26 2.6 19.0 ) (Page 6B-4)
Steering shaft holder bolt 23 2.3 16.5 ) (Page 6B-8)
Steering shaft lower nut 49 4.9 35.5 ) (Page 6B-9)
Tie-rod end nut 29 2.9 21.0 ) (Page 6B-9)
Tie-rod lock-nut 29 2.9 21.0 ) (Page 6B-9)