Suzuki LT-A400, Service Manual

Page: 39 / 502

Maintenance and Lubrication: 0B-10
Front Differential Gear Oil Replacement (LT-
A400F, LT-F400F)
B827H10206010
Replace front differential gear oil
Every 2 years
Replace the oil filter differential gear oil in the following
procedures:
1) Place the vehicle on level ground.
2) Remove the front under cover. Refer to “Exterior
Parts Removal and Installation in Section 9D
(Page 9D-3)”.
3) Remove the oil filter plug (1) and oil level plug (2).
4) Drain front differential gear oil by removing the oil
drain plug (3).
5) Tighten the oil drain plug (3) to the specified torque.
CAUTION
!
Replace the gasket washers with a new one.
Tightening torque
Front drive (differential) gear oil drain plug (a):
32 N·m (3.2 kgf-m, 23.0 lb-ft)
6) Pour fresh oil through the oil filler hole until it
overflows from the oil level hole. When performing
an oil change, the front differential will hold about
300 ml (10.1/10.6 US/Imp oz) of oil. Use hypoid gear
oil SAE #90, API grade GL-5.
NOTE
Use hypoid gear oil SAE #80, API grade GL-5,
if the vehicle is ridden where the ambient
temperature is below 0
°
C (32
°
F).
Front differential gear oil capacity
300 ml (10.1/10.6 US/Imp oz)
7) Tighten the oil level plug (2) and oil filler plug (1) to
the specified torque.
CAUTION
!
Replace the gasket washers with new ones.
Tightening torque
Front drive (differential) gear oil level plug (b): 8
N·m (0.8 kgf-m, 6.0 lb-ft)
Front drive (differential) gear oil filler plug (c):
35 N·m (3.5 kgf-m, 25.5 lb-ft)
1
2
I827H1020014-01
3
I827H1020015-01
(a)
3
I827H1020016-01
(c)
1
(b)
2
I827H1020017-01