41
NOTE:
The communication range is a distance of 1 m
(40 in) between the keyless fob and the keyless
control unit.
If the Keyless Start System fails to turn ON, the
buzzer emits one (1) long sound and five (5)
short sounds.
In this case, repeat the procedure again.
4. Push the main switch to start the engine.
NOTE:
By pressing the main switch once, the starter
motor turns for 4 seconds continuously until the
engine starts.
NOTICE
If you hold in the main switch to start the
engine, the starter system can be damaged.
Push the main switch and release it to start
the engine. The engine will crank continu-
ously for 4 seconds or until the engine starts.
ON & OFF
ON & OFF
PUSH
START
STOP
PUSH
START
STOP
NOTE:
The continuous operating time of the starter
motor is set at five seconds.
When this time is exceeded, the starter motor
will automatically stop.
If the motor stops, wait about ten seconds for
the motor to cool down and try again.
5. Warm up the engine for about 5 minutes.
If not equipped with Keyless Start System:
1. Squeeze the fuel line priming bulb several
times until you feel resistance.
NOTICE
If the OIL lamp remains lit while operating the
outboard, the oil level may be low enough to
damage the engine.
Stop the engine and check the oil level.
NOTICE
Operating the engine at high RPM or “wide
open throttle” immediately after starting the
engine without allowing the engine to warm
up may cause engine failure.
Always allow the engine to warm up suffi-
ciently before operating it at high speeds.
