Sutter Instrument Lambda 721, Operation Manual

Page: 10 / 62

LAMBDA 721 OPERATION MANUAL – REV. 1.10C (20210517)
viii
Figure E-3. Lambda 721 rear panel, connectors, and controls. ........................................................... 36
Figure E-4. Lambda 721 left-side panel and DIP switches. ................................................................. 36
Figure E-5. LED cube placement. ........................................................................................................... 36
TABLE OF TABLES
Table 2-1. Configuration Switches 1 – 8 definitions. .............................................................................. 8
Table 4-1. USB-VCP interface serial port settings. .............................................................................. 15
Table 4-2. Lambda 10-x Mode (‘L’ or ‘l’) Command. ............................................................................ 16
Table 4-3. Lambda 10 Series compatible LED selection commands. .................................................. 17
Table 4-4. LED selection commands using ASCII digits. ..................................................................... 18
Table 4-5. TTL Mode (‘T’ or ‘t’) Command. .......................................................................................... 18
Table 4-6. Start Ring Buffer Run (‘R’ or ‘r’) Command. ...................................................................... 19
Table 4-7. Return values while running the Ring Buffer. .................................................................... 19
Table 4-8. Stop TTL Mode or Ring Buffer Run (‘O’ or ‘o’) Command. .............................................. 19
Table 4-9. Load Ring Buffer (‘B’ or ‘b’) Command. .............................................................................. 20
Table 4-10. ‘B’ or ‘b’ Command Stop Loading the Ring Buffer entry value. .................................... 20
Table 4-11. ‘B’ or ‘b’ Command Ring Buffer entry values. .................................................................. 20
Table 4-12. Change the on/off state of one or more LEDs (‘M’ or ‘m’) Command. ........................... 21
Table 4-13. Set LED Power Level (‘P’ or ‘p’) Command. .................................................................... 22
Table 4-14. Get LED ON/OFF Status (‘S’ or ‘s’) Command................................................................ 22
Table 4-15. Get Lambda 10-3 Compatible Controller Type and Configuration Command. ............ 23
Table 4-16. Get Lambda 10-3 Compatible Controller Type and Configuration Command. ............ 24
Table 5-1. Cable specifications. ............................................................................................................... 34
Table E-1. Configuration Switches 1 – 8. ............................................................................................... 36
Table E-2. Serial port settings. ................................................................................................................ 37
Table E-3. Lambda 721 external control commands. ........................................................................... 38
Table E-4. Lambda 10 Series compatible LED selection commands. ................................................. 41
Table E-5. LED selection commands using ASCII digits. .................................................................... 42
Table E-6. Ring Buffer entry values. ...................................................................................................... 43
Table E-7. Return values while running the Ring Buffer. ................................................................... 43
Table E-8. ‘M’ Command 1 st argument (2 nd byte) values for individual LED ON/OFF state bit
encoding. .................................................................................................................................. 44