03/01/16
670- 00017B
21
10.0 Inspection and Maintenance
FOLLOW ALL SAFETY INSTRUCTIONS CONTAINED
IN SECTION 3.0 OF THIS MANUAL BEFORE
PERFORMING INSPECTION AND MAINTENANCE
PROCEDURES ON THIS PRODUCT. FAILURE TO
FOLLOW THE INSTRUCTIONS IN THIS MANUAL
COULD RESULT IN PROPERTY DAMAGE,
PERSONAL INJURY OR DEATH.
The Movotec
®
Crank Driven “Bolt-On” Lift System should be inspected regularly to
detect any condition which has or may lead to excessive component wear or premature
failure. Special attention should be given to the following possible causes of system
failure.
10.1 Changing Load Conditions
Overload conditions should be promptly corrected to prevent premature wear of
mechanical components. This will also prevent overheating and premature failure of
electrical components.
10.2 Contamination
Although surgical cleanliness is not required, ordinary cleaning practices will pay off in
increased service life of the lift system. Dust and dirt can restrict ventilation for electrical
components and cause wear in moving components such as shafts and bearings. An
attempt should be made to keep the system components reasonably clean throughout their
useable service life.
10.3 Hydraulic Tubing Damage
Check the hydraulic tubing for visible signs of aging and wear. Replacement of damaged
hydraulic tubing will prevent future breakdowns and possible injury to personnel.
