SureShot AC6.E, Service Manual, Page: 9 / 28

9
3. CLEANING
Cleaning: Catch Tray
Note: The catch tray at the front and must be removed for cleaning, by lifting it up and off.
1. Rinse the tray with lukewarm potable water.
2. Place the tray in a hot water wash at a minimum water temperature of 140 ºF or 60 ºC.
•
A good quality general cleaner should be added to the hot wash water at the concentrations
recommended by the detergent supplier.
3. Wash thoroughly, using a bottle brush to reach all the corners and crevices.
•
If a dishwasher is available at the location, this step may be carried out by placing the tray in
the dishwasher and washing on the pot cycle.
4. After washing, rinse the tray well with lukewarm potable water.
5. Turn the tray upside down. Air dry. Dry thoroughly.
.
Cleaning: The Exterior
1. Use a soft cloth to wipe down the exterior surfaces of the dispenser to maintain the lustre of the
stainless steel finish.
Do not use any abrasive materials – a stainless steel cleaner is recommended.
Cleaning: The Sugar Hopper
1. Unplug the dispenser from its power source.
2. Empty the product hopper:
a. Remove the lid from the hopper compartment.
b. If you have a dispenser model with a top screen, remove that screen and be aware that the
bottom screen is still in the hopper. Do not lose the bottom screen – it is necessary for the
proper operation of the dispenser and the optional Clumpbuster.
c. Remove the sugar.
d. Remove the bottom screen.
3. Open the valve door by removing the black valve thumbscrew.
4. Remove the black thumbscrew on the back of the hopper by turning it counterclockwise. See step
3, page 7.
7. Lift the hopper compartment (including the tube) off the dispenser.
8. Remove the product dispensing tube as shown on Page 7.
9. HOPPER: Wash the hopper compartment carefully with warm, soapy water and rinse with warm
water.
10. Dry the compartment.
Dry thoroughly.
11. SCREENS: Wash the screens separately using warm, soapy water and rinse with warm water.
12. Dry the screens.
Dry thoroughly.
13. DISPENSE TUBE: Install a new dispensing tube.
14. Re-assemble the dispenser as shown on Page 7. When re-assembling the dispenser, ensure
that the bottom screen is in place. Ensure that the dispensing tube is properly aligned in the valve.
14. Plug the dispenser back in to the power source.
15. Push any button and the valve will open and close.
16. Refill the hopper compartment with sugar.
17. Replace the lid.