SureShot AC6.E, Service Manual, Page: 4 / 28

4
1. SETUP
Uncrating the Dispenser
1. Remove the dispenser from the packaging: unfold the packing material and lift the dispenser out of
the box.
2. Prior to use, read this Operations Manual and store it for future reference.
3. Remove the plastic protective covering from the stainless steel exterior of the dispenser, by peeling it
off. Hold the dispenser firmly at the top and peel in sections from top to bottom.
4. Turn the black valve thumbscrew counter-clockwise to open the valve door and ensure that the
dispense tube is centered in the dispense valve.
5. Close the valve door and turn the black valve thumbscrew clockwise to secure it.
6. Cut the tube so that it is no longer than ¼” below the bottom of the dispense valve.
7. Remove the packing tape holding the catch tray in place at the dispenser front. See Figure below.
8. Confirm that the dispenser hopper contains the bottom stainless steel strainer and the optional top
strainer (if your dispenser is a model that uses the top strainer).
Reshipment
Packaging for shipment is done in the reverse order of uncrating. If packaging is not available, it
can be purchased locally, or from our factory by request. Any damage occurring in transit of the returned
goods and caused by improper packaging is not considered a defect covered by warranty.
Installation and Location of the Dispenser in your Business
•
Place the dispenser where it will best serve your operation.
•
Do not place the dispenser too close to a source of heat or moisture.
•
The dispenser must be placed on a level surface.
•
Counters, platforms, or shelves should be strong enough to support the dispenser and a full
product load.
•
Leave clear space around the dispenser, approximately one inch on all sides.
•
Do not remove the legs from the dispenser or allow it to sit flat on the counter. Make sure the
rubber feet at the ends of the legs of the dispenser are in place. If one has loosened during
shipping, insert it. You may use a small screwdriver to tuck the rubber into the holes. Contact
A.C. Dispensing Equipment Inc. for replacement feet at 1-888-777-9990 or 1-902-865-9602.
•
Place the dispenser at the appropriate serving height so that staff drawing product from the
dispenser can operate the buttons and easily place and remove cups.