SureCall | 48346 Milmont Drive, Fremont CA 94538 | 1-888-365-6283 | [email protected]
15
CAUTION: VERIFY THAT ALL INTERIOR ANTENNAS
MEET THE SEPARATION REQUIREMENTS
DESCRIBED IN THE PREVIOUS CHAPTER AND THAT
NO ANTENNA IS AIMED TOWARD THE EXTERIOR
ANTENNA.
CAUTION: DO NOT CONNECT AN INTERIOR
ANTENNA TO THE SPLITTER INPUT.
4.4 - Internal Antennas
Mount the interior antenna(s) in the location(s) you selected during the planning process. Be sure to
follow the instructions included with the antenna(s) for a safe installation. Remember:
• Dome antennas should be mounted in the ceiling as close to the center of the desired coverage
area as possible with the domed side pointing down.
• Flat panel antennas should be wall-mounted as close as possible to center of the wall at one end of
long narrow space.
1. Mount the antenna.
2. Connect a length of cable to the antenna and tighten until hand-tight.
3. If you are installing multiple antennas, run the cable to the splitter location and connect the cable
to one of the outputs on the splitter.
4. Connect another length of cable to the input side of the splitter (if used) and run this cable to the
BDA location.
5. It is important to keep the cable runs equal or use taps to ensure a harmonious install.
Installation