Sure-Feed Engineering SE-1200-E, Operations & Parts Manual

Page: 9 / 39

Sure-Feed
Engineering
Inc
8
SECTION 5
Sure-Feed Engineering Inc.
Troubleshooting Guide
Problem Solution
Feeder will not run. Check circuit breaker condition.
Check outlet power source.
Check power switch.
Feeder runs but no material is being
dispensed. Check material supply.
Remove all material and follow setup
procedure.
Check rollers and belts for excessive
wear or dirt.
Feeder does not create a gap
between pieces. Lower separator adjustment and
observe. If a gap is not present after this
adjustment, return separator to original
position and move the back guide
forward.
Feeder does not detect material. Adjust position of the sensor.
Thick material does not feed well. Decrease the height at the back of the
material stack.
Increase the opening at the separation
device (the thicker the material the less
critical the setting is).