Sure-Feed Engineering SE-1200-E, Operations & Parts Manual

Page: 4 / 39

Sure-Feed
Engineering
Inc
3
Sure-Feed Engineering Inc.
Installation Instructions Cont’
12. Position the feeder on the inserter table so that the edge of the leading piece
is between the material guide tabs and the bottom of the front hopper plate.
13. Adjust the sensor so that the piece advances out further and is well within the
gripper jaw opening.
14. With the speed control set to minimum, jog the inserter to remove the piece
staged in the gripper jaw and return the gripper jaw to the furthest inward
position.
15. Turn the speed control up slightly. This should advance the next piece into
the gripper jaw. Adjust the sensor, material guide tabs and position the SE
1200 EI as needed to align the paper path into the gripper jaw.
16. Load the SE 1200 EI with at least a full handful of material and cycle the
inserter.
17. Notice the material path and the presentation to the gripper jaw, as this is
most important as the cycle speed is increased.
18. Cycle the inserter at full production speed adjusting the SE 1200 EI speed so
that the piece being presented to the gripper jaw is there well ahead of the
end of the forward stroke.