Sure-Feed Engineering SE-1200-E, Operations & Parts Manual

Page: 10 / 39

Sure-Feed
Engineering
Inc
9
Sure-Feed Engineering Inc.
Troubleshooting Guide Cont.
Problem Solution
Thin material does not feed. Adjust separation device as described in
section 2.
Remove material and fan the stack
allowing air to separate the pieces.
Raise the rear of the material stack by
moving the wedge forward.
Material feeds double. After confirming set up is correct,
remove the separator and inspect the o-
rings. If the o-rings are worn past the
depth of the groove in the separating
wheel, they will not be effective. Rotate
the o-ring in the groove until a new
section of o-ring is in position to contact
the material. Reinstall the separator and
reset the gap.