brake handle will change and needs to be adjusted again. (see “adjust brake handle”)
!
Fig 59
13.2 Adjust brake handle
Sit on the seat of
bike
and adjust brake handle with fingers. Adjust their angle to make
them align to your arms when your fingers are on brake handle.
Adjust the position of brake on handlebar until users can pull the edge of brake handle
with one or two fingers.
Adjust the range of brake handle with tools until users can reach handle easily with
fingers.
!
After adjusting the position of brake
handle
, adjust the position of accelerator
and shift lever in case of influencing brake.
14 Disassembly
14.1 Dismount handle of accelerator
Dismount handle of accelerator according to the following steps:
• dismount
wire protector buckle
• cut
off
cable tie
•
Loosen
bolts of connector of accelerator
• release
throttle
cable
• Pull handle of accelerator out from handlebar
14.2 Dismount handlebar
grip
Lift the edge of left handle
bar grip
and spray contract cleaner between handle
bar grip
and handlebar to dismount handle. Then, pull
the
handle
bar grip
out.
Before dismounting right handle
bar grip
, cut right handle
bar grip
open longitudinally
carefully until it can be opened and dismounted.
Before installing a new handle
bar grip
, clean handlebar(left) or handle of
accelerator(right),
apply
polyurethane adhesive on its surface and plug handle
bar grip
into its end.
14.3 Dismount
throttle holder
Dismount
throttle holder
according to the following steps:
• Unscrew the bolts of
throttle holder
.
• Take
throttle
out from
throttle holder
and release
throttle
cable
•
take throttle
cable out from
throttle holder
• Pull
the throttle
wire out.
14.3.1 Install hand-held shift lever
• pass
throttle
wire through shell of
throttle holder
and screw
throttle holder
shell and
threaded rod of
throttle
cable
• Pull core of
throttle
cable out and
plug handlebar into
handlebar
grip
• Connect core of
throttle
wire to handle of
throttle
. Cover handlebar with
throttle holder
and
handle of throttle
.
• Rotate
throttle
slightly until it moves and bounces back normally and smoothly.
•
Screw throttle holder
shell of A and B
together
with bolts. When
tightening the
bolts,
adjust the angle of
throttle holde
r to ensure no object will influence the motion of brake
handle.
• Operate
throttle
to make
sure
it
moves
normally.