12
RE-ATTACHING HAND-HELD STEAMER TO MOP BODY
1. Remove all attachments.
2. Insert the Power Cord (22) into the clip on the side of the Hand-Held
Steamer body. (Illust. 47)
Illust.47
Illust.48
Illust.49
Illust.50
3. Align the Hand-Held Steamer Adapter (23) with the hole in the Mop Body (8) and insert.
(Illust. 48)
4. Push the Hand-Held Steamer against the Mop Body until it clicks into place. (Illust. 49)
5. Lock the Hand-Held Steamer to secure in place by bringing down the Hand-Held Steamer
Release Tab (12). (Illust. 50)
AFTER USE
1. Unplug unit from electrical outlet.
2. Remove Mop Pad (2) from Mop Head (3).
NOTE: Allow Mop Pad to cool and remove carefully as it could still be hot!
3. Empty any remaining water from the water tank (6) prior to storage.
4. Let any water (due to condensation) drain from the steam nozzle prior to storage.
5. Wrap Power Cord (22) around Cord Holder (15) to store.
6. Wipe all surfaces of the SteamTek3 Mop with a soft cloth and store in a safe and dry area
away from children and pets.
7. The Microfiber pads (1) are machine washable in warm water.
AIR DRY ONLY – DO NOT DRY IN MACHINE
DO NOT BLEACH
DO NOT USE FABRIC SOFTENER
CAUTION! :
Upright storage of the SteamTek3 Steam Mop with a wet Microfiber Mop Pad could
result in white mark formations on your floor. In the event that this occurs, use a little vinegar
to clean the area.
IMPORTANT! : Always empty the water tank after using your SteamTek 3 Steam Mop! If
there are any deposits remaining in the tank, add a little water to the tank, close the cap,
shake, open cap then empty. Repeat as necessary. DO NOT IMMERSE IN WATER!
