Chapter 2: Installation
2-13
JP18
JP17
JPWR2
I-SATA1
I-SATA3
J4
JKVM1
JPB1
JPG1
JWD1
JPME1
JPME2
JSD1
JBT1
HEARTBEAT LED
UID LED
MICRO-LP PCI-E 3.0 X8
X9SCE-F
PWR
P1-DIMMB2
P1-DIMMB1
P1-DIMMA2
P1-DIMMA1
CPU1
LED4
BIOS
JP16
UID SW
I-SATA2
I-SATA0
SW
8
Rev. 1.0a
2-6 Connecting Cables
This section provides brief descriptions and pin-out definitions for onboard connec
-
tors or headers. Be sure to use the correct cable for each header or connector.
IF + POWER
This edge connector, located on the opposite end of the motherboard from the I/O
back panel, is used to connect the motherboard to the back plane of the server
chassis. Through this connector, the motherboard receives its power and commu-
nicates with other components installed in the system.
IF + Power
SATA DOM Power
A
B
Image rotated 90
◦
A
SATA DOM Power
The SATA DOM Power header on JSD1
is used to supply power to SATA Disk-
on-Module (DOM) solid-state storage
devices. See the table on the right for
pin definitions.
DOM PWR
Pin Definitions
Pin# Definition
1
+5V
2
Ground
3
Ground
B
