Supero X7DCT-3, User Manual

Page: 58 / 93

3-2
X7DCT-L/X7DCT-LF/X7DCT-3/X7DCT-3F/X7DCT-3IBXF User's Manual
No Video
If the power is on, and you have no video, please remove all the add-on 1.
cards and cables.
Use the speaker to determine if any beep codes exist. Refer to the Appendix 2.
for details on beep codes.
Losing the System’s Setup Confi guration
Make sure that you are using a high quality power supply. A poor quality 3.
power supply may cause the system to lose the CMOS setup information.
Refer to Sections 1-6 and 2-6 for details on recommended power supplies.
The battery on your motherboard may be old. Check to verify that it still sup- 4.
plies ~3VDC. If it does not, replace it with a new one.
If the above steps do not fi x the Setup Confi guration problem, contact your 5.
vendor for repairs.
Memory Errors
Make sure the DIMM modules are properly and fully installed. Check if 1.
DIMMs of different speeds or types have been installed. Also make sure that
the BIOS setup is confi gured for the fastest speed of RAM used.
It is recommended to use the same RAM speed for all DIMMs in the system. 2.
Make sure you are using the correct type of DDR2 Buffered (Registered)
ECC 667/533 SDRAM (*recommended by the manufacturer.)
Check for bad DIMM modules or slots by swapping a single module between 3.
four slots and noting the results. Make sure all memory modules are fully
seated in their slots. As an interleaved memory scheme is used, you must
install two modules at a time, beginning with 1A and 1B, then 2A and 2B,
and so on (see Section 2-3). Check the position of the 115V/230V switch on
the power supply.
3-2 Technical Support Procedures
Before contacting Technical Support, please take the following steps. Also, note that
as a motherboard manufacturer, Supermicro does not sell directly to end-users, so
it is best to fi rst check with your distributor or reseller for troubleshooting services.