Supero SUPERSERVER 6027R-72RFT+, User Manual

Page: 47 / 108

Chapter 5: Advanced Serverboard Setup
5-17
Reset Button
The Reset Button connection is
located on pins 3 and 4 of JF1 and
attaches to the reset switch on the
computer chassis. See p. 5-4 and the
table on the right for pin definitions.
Power Button
The Power On connection is on pins
1 and 2 of JF1. These should be con-
nected to the chassis power button.
See p. 5-4 and the table on the right
for pin definitions.
5-8 Connector Definitions
Required Connection
ATX Power 24-pin Connector
Pin Definitions
Pin# Definition Pin # Definition
13 +3.3V 1 +3.3V
14 -12V 2 +3.3V
15 COM 3 COM
16 PS_ON 4 +5V
17 COM 5 COM
18 COM 6 +5V
19 COM 7 COM
20 Res (NC) 8 PWR_OK
21 +5V 9 5VSB
22 +5V 10 +12V
23 +5V 11 +12V
24 COM 12 +3.3V
Reset Button
Pin Definitions (JF1)
Pin# Definition
3 Reset
4 Ground
Power Button
Pin Definitions (JF1)
Pin# Definition
1 Power Signal
2 Ground
Secondary Power Connector
JPW2 and JPW3 must also be con-
nected to the power supply. See the
table on the right for pin definitions.
+12V 8-pin Power
Pin Definitions
Pins Definition
1 - 4 Ground
5 - 8 +12V
Warning : To provide adequate power
supply to the motherboard, be sure
to connect JPW1 and both JPW2 and
JPW3 to the power supply. Failure
to do so will void the manufacturer
warranty on your power supply and
motherboard.
Power Connectors
A 24-pin main power supply connec-
tor (JPW1) and two 8-pin CPU power
connectors (JPW2/3) must be con-
nected to the power supply. These
power connectors meet the SSI EPS
12V specification. See the table on the
right for pin definitions.