Supero SUPERSERVER 6027R-72RFT+, User Manual

Page: 39 / 108

Chapter 5: Advanced Serverboard Setup
5-9
Memory Support
The X9DR7-TF+ supports up to 768 GB of ECC registered DDR3-1600/1333/1066/800
SDRAM. Both 1.5V and 1.35V DIMMs are supported. For best performance, install
pairs of memory modules of the same type and speed. Please refer to our web
site for any updates to supported memory. All channels will run at the fastest com-
mon frequency. Memory may not run at the full 1600 MHz with DDR3-1600 DIMMs
installed in all 24 slots.
DIMM Installation
Installing Memory Modules
1. Insert the desired number of DIMMs into the memory slots starting with P1-
DIMMA1. See the Memory Installation Tables below.
2. Insert each DIMM module vertically into its slot. Pay attention to the notch
along the bottom of the module to avoid installing incorrectly (see Figure 5-3).
3. Use your thumbs to gently press down on both ends of the DIMM module
until it snaps into place in the slot. Repeat for all modules.
4. Press the release tabs to the locked positions to secure the DIMM module
into the slot.
!
CAUTION! Exercise extreme care when installing or removing DIMM
modules to prevent any possible damage.
5-5 Installing Memory
To Install: Insert module
vertically and press
down until it snaps into
place. Pay attention to
the alignment notch at
the bottom.
To Remove:
Use your thumbs to
gently push the release
tabs near both ends of
the module. This should
release it from the slot.
Figure 5-3. DIMM Installation
Top View of DDR3 Slot
Release Tab
Release Tab
Notch should align with the
receptive key point on the
slot.
Notch
Notch
Front View