Supero SUPERSERVER 6026T-3RF, User Manual

Page: 64 / 100

6-4
S
UPER
S
ERVER 6026T-3RF User's Manual
Figure 6-2. Removing System Cooling Fans
6-4 Drive Bay Installation/Removal
Accessing the Drive Bays
SAS/SATA Drives: You do not need to access the inside of the chassis or remove
power to replace or swap SAS/SATA drives. Proceed to the next step for instructions.
You must use standard 1" high, SAS/SATA drives in the system.
Note: Refer to the following ftp site for setup guidelines: <ftp://ftp.supermicro.com/
driver/SAS/LSI/LSI_SAS_EmbMRAID_SWUG.pdf> and Supermicro's web site for
additional inmformation < http://www.supermicro.com/support/manuals/>.
DVD-ROM: For installing/removing the DVD-ROM drive, you will need to gain ac-
cess to the inside of the server by removing the top cover of the chassis. Proceed
to the "DVD-ROM Installation" section later in this chapter for instructions.
!
Enterprise level hard disk drives are recommended for use in
Supermicro chassis and servers. For information on recommended
HDDs, visit the Supermicro Web site at http://www.supermicro.com/
products/nfo/fi les/storage/SAS-1-CompList-110909.pdf