Supero SuperServer 6024H-8R, User Manual

Page: 65 / 124

Chapter 6: Advanced Chassis Setup
6-7
SCA Backplane
The SCSI drives plug into a SAF-TE compliant SCA backplane that provides
power, SCSI ID and bus termination. A RAID controller can be used with
the SCA backplane to provide data security. The operating system you use
must have RAID support to enable the hot-swap capability of the SCSI
drive. The SCA SCSI backplane is already preconfigured; there are no
jumpers or switches.
SCSI ID#0
SCSI ID#1
SCSI ID#2
SCSI ID#3
SCSI ID#4
SCSI ID#5
SCSI ID#6 is used for the SAF-TE Controller
Figure 6-5. SCSI SCA Backplane
Removing the air shroud
Under most circumstances you will not need to remove the air shroud to
perform any service on the system. However, if you wish to temporarily
remove it (the air shroud sould always be in place when the system is
operating), please follow this procedure.
Begin by depressing the tabs at the front and rear of the shroud to
unlock it, then lift it up and out of the chassis. To reinstall, simply
position the air shroud in its proper place and push it in until you hear it
click.