Supero SUPERSERVER 6023P-8, User Manual

Page: 68 / 104

6-10
S
UPER
S
ERVER 6023P-8R/6023P-8 Manual
6-6 Power Supply: 6023P-8
The SuperServer 6023P-8 has a single 400 watt power supply. This power
supply has an auto-switching capability, which enables it to automatically
sense and operate at a 100V to 220V input voltage.
Power Supply Failure
If the power supply unit fails, the system will shut down and you will need
to replace the power supply unit. Replacement units can be ordered di-
rectly from Supermicro (see contact information in the Preface). The re-
placement part is p/n PWS-027, model SP402-2C. As there is only one
power supply unit in the 6023P-6, the server must be powered down be-
fore removing and/or replacing the power supply for whatever reason.
Removing/Replacing the Power Supply
1. Removing the power supply:
First turn the power switch on the control panel off, then unplug the
power cord from the system. Remove the chassis cover by pressing the
two release buttons on the top of the chassis (near the front) and push
the chassis top rearward about one inch. To remove the failed power
unit, remove all screws that connect the power supply to the chassis
(two at the rear, four at the side, one on the bottom and one at the
front). The power supply can then be lifted straight up and out of the
chassis.
2. Installing a new power supply:
Replace the failed unit with another unit of the same input voltage, output
voltage and wattage. It is highly recommended to replace it with exactly
the same model power supply. Carefully insert the new unit into position
in the chassis and secure it with the eight screws described in the
paragraph above. Then reconnect the power cord, replace the chassis
top cover and reposition the unit back into the rack. Finish by depressing
the power button on the chassis front panel.